Filter
Top Products
cGPSmapper Manual Map Project
http://cgpsmapper.com/ 10 of 100
Codepage=xx
0 full-byte (8-bit) character coding with the
specified codepage is used (depending on the GPS
firmware)
0 single-byte coding
Note: All labels must be written in CAPITALS if a codepage
is used
Note: The delimiters for road numbers ( refer to section
4.2.6, on page 30, for details) are different if full-byte coding
is used.
Note: Special codes are different for 8-bit coding!
Default = 0
Datum=xxx
W84 WGS-84
Custom Custom
dx, dy, dz, semiMajorAxis, invFlattening
E.g. for (for WGS84): Custom: 0,0,0,6378137.000,
298.257223563
W84 & Custom refer to the
Datum_List.txt file (in the cGPSmapper directory)
for the full list of supported datums
Default = W84
Transparent=x
Y a transparent map will be created
N a transparent map will not be created
Default = N
When a transparent map is displayed on a GPS unit, features
in the unit's basemap will also be visible. If your map is not
transparent, it will obscure the basemap when visible.
MG=x
Lock on road, search for intersection and show next street
name active:
Y Yes
N no
Default = N
π
Numbering=x
Lock on road, show next street name and house numbers
along street active:
Y Yes
N no
Default = N
Routing=x
Lock on road, show next street name active, house numbers
along street and routable maps active:
Y Yes
N no
Note: for routable maps a special data format required!
Default = N