Filter
Top Products
GPSMAP
®
6000/7000 Series Owner’s Manual 81
Radar
Measuring the Range and Bearing to a Target Object
You must show the VRM and the EBL before you can adjust them (page 80).
The VRM and the EBL congured for one mode are applied to all other radar modes.
1. From the Home screen, select .
2. Select , , , or .
3. Complete an action:
• Select >> for Cruising, Harbor, or Offshore Mode.
• Congure the setting for the short-range screen in Dual Range mode. Select > >
> for the GPSMAP 6000 series. Select > >
for the GPSMAP 7000 series.
• Congure the setting for the long-range screen in Dual Range mode. Select > >
> for the GPSMAP 6000 series. Select > >
for the GPSMAP 7000 series.
4. Complete an action:
• For the GPSMAP 6000 series, use the to adjust the diameter of the VRM and the angle of the
EBL, so that the intersection point of the VRM and EBL is at the target location
• For the GPSMAP 7000 series, touch the target location.
The range and the bearing to the target location appear in the upper-left corner of the screen.
5. Select .
Waypoints and Routes on the Radar Screen
Marking a Waypoint on the Radar Screen
1. From the Home screen, select .
2. Select a radar mode.
3. Complete an action:
• For the GPSMAP 6000 series, use the to select a location.
• For the GPSMAP 7000 series, touch a location.
4. Select .
Showing Waypoints on the Radar Screen
You can show waypoints that are within the range shown on the Radar screen. This setting does not apply to
the Radar Overlay.
1. From the Home screen, select > > > .
2. Complete an action:
• Select to show all waypoints.
• Select to show only waypoints associated with the currently active route.