Filter
Top Products
GPSMAP
®
6000/7000 Series Owner’s Manual 51
Almanac, Environmental, and On-boat Data
Depth Data
Viewing the Depth Graph
The chartplotter must be connected to a depth-capable transducer to capture the data shown on the depth
graph.
From the Home screen, select > > .
If you have turned on and congured the shallow water and deep water alarms (page 106), the graph shows
in red any water depth data that is less than the depth specied for the shallow water alarm, and it shows in
red any water depth data that is greater than the depth specied for the deep water alarm.
On-boat Data
Engine Gauges
Viewing Engine Gauges
You must be connected to a NMEA (National Marine Electronics Association) 2000 network capable of
sensing engine data to view engine gauges. See the GPSMAP 6000/7000 Series Installation Instructions for
details.
From the Home screen, select > .
Cycling Through Engine and Fuel Gauge Screens
1. From the Home screen, select > .
2. Move from one gauge screen to the next:
• For the GPSMAP 6000 series, use the .
• For the GPSMAP 7000 series, select the left and right arrows at the top of the page.
The chartplotter shows the next engine gauge or fuel gauge screen.
3. Repeat step 2 to cycle through all the engine gauge and fuel gauge screens.
Customizing Engine and Fuel Gauge Limits
You can congure up to four values for each engine gauge or fuel gauge, to establish the upper and lower
limits of the gauge, and the range of desired standard operation. When a value exceeds the range of standard
operation, the gauge face or bar becomes red.
Setting Description
Scale minimum This value is less than the scale minimum, and it represents the lower limit of the gauge�
This setting is not available on all gauges�
Scale maximum This value is greater than the scale maximum, and it represents the upper limit of the
gauge� This setting is not available on all gauges�
Rated minimum Represents the minimum value of the standard operating range�
Rated maximum Represents the maximum value of the standard operating range�
1. From the Home screen, select > > > > .
2. Select a gauge.
3. Select > .