942 IPv6 PIM Commands
ipv6 pim bsr-candidate
Use the ipv6 pim bsr-candidate command to configure the router to advertise
itself as a bootstrap router (BSR). Use the no form of this command to return
to the default configuration.
Syntax
ipv6 pim bsr-candidate vlan {
vlan-id hash-mask-len
bsr-priority
}
no ipv6 pim bsr-candidate vlan {
vlan-id
}
Parameter Description
Default Configuration
None - The router does not advertise itself as an BSR candidate.
Command Mode
Global Configuration mode
User Guidelines
All multicast groups with the same hash value correspond to the same RP.
Lower priority values are preferred.
Example
console(config)#ipv6 pim bsr-candidate vlan 10 16 0
Parameter Description
vlan-id A valid VLAN identifier with multicast routing enabled.
hash-mask-len The length of the BSR has to be AND’ed with the multicast
group address. Range 0-32. Default 0.
bsr-priority The advertised priority of the bsr-candidate.
Range: 0–255.
Default 0.
2CSPC4.XModular-SWUM200.book Page 942 Thursday, March 10, 2011 11:18 AM
