IP Addressing Commands 463
User Guidelines
When setting the netmask/prefix length on an IPv4 address, a space is
required between the address and the mask or prefix length. Setting an IP
address on the out-of-band port enables switch management over the service
port.
Example
The following examples configure the service port with IP address
131.108.1.27 and subnet mask 255.255.255.0 and the same IP address with
prefix length of 24 bits.
console(config)#interface out-of-band
console(config-if)#ip address 131.108.1.27
255.255.255.0
console(config-if)#ip address 131.108.1.27 /24
ip address-conflict-detect run
Use the ip address-conflict-detect run command in Global Configuration
mode to trigger the switch to run active address conflict detection by sending
gratuitous ARP packets for IPv4 addresses on the switch.
Syntax
ip address–conflict–detect run
Parameter Description
This command does not require a parameter description.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration
2CSPC4.XModular-SWUM200.book Page 463 Thursday, March 10, 2011 11:18 AM
