1034 Multicast Commands
show ip multicast
Use the show ip multicast command in Privileged EXEC mode to display the
system-wide multicast information.
Syntax
show ip multicast
Syntax Description
This command has no arguments or keywords.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC modes
User Guidelines
This command has no user guidelines.
Example
The following example displays system-wide multicast information.
console#show ip multicast
Admin Mode........................... Enabled
Protocol State....................... Non-Operational
Used The total number of addresses in the multicast address table.
Static addresses The number of addresses in the multicast address table that are
static IP addresses.
Dynamic
addresses
The number of addresses in the multicast address table that were
learned dynamically.
Forbidden
addresses
The number of addresses in the multicast address table that are
forbidden IP addresses.
2CSPC4.XModular-SWUM200.book Page 1034 Thursday, March 10, 2011 11:18 AM
