SNMP Commands 1489
multiple-users Enable/Disable sending traps when
multiple logins
active.
ospf Enable/Disable OSPF Traps.
ospfv3 Enable/Disable OSPF Traps.
pim pim
spanning-tree Enable/Disable sending Spanning
Tree traps.
snmp-server engineID local
Use the snmpserver engineID local command in Global Configuration mode
to specify the Simple Network Management Protocol (SNMP) engine ID on
the local device.
To remove the configured engine ID, use the no form of this command.
Syntax
snmp-server engineID local {
engineid-string
| default }
no snmp-server engineID local
• engineid-string — The character string that identifies the engine ID. The
engine ID is a concatenated hexadecimal string. Each byte in hexadecimal
character strings is two hexadecimal digits. Each byte can be separated by
a period or colon. (Range: 6-32 characters)
• default — The engineID is created automatically, based on the device
MAC address.
Default Configuration
The
engineID
is not configured.
Command Mode
Global Configuration mode
2CSPC4.XModular-SWUM200.book Page 1489 Thursday, March 10, 2011 11:18 AM
