1588 System Management Commands
NOTE: The show switch stack-port command in Stack Configuration mode is not
supported by the PCM8024 and PCM8024-k switches.
Use the show switch command
to display information regarding the switches in a stack.
Example
console(config-stack)#stack-port tengigabitethernet
1/0/3 stack
console(config-stack)#
standby
Use the standby command to configure the standby in the stack. This unit
comes up as the master when the stack failover occurs. Use the no form of
this command to reset to default, in which case, a standby is automatically
selected from the existing stack units if there no preconfiguration.
Syntax
standby
unit
no standby
•
unit
— Valid unit number in the stack. (Range: 1–12 maximum. The range
is limited to the number of units available on the stack.)
Default Configuration
The default configuration is to allow the software to automatically select a
standby unit.
Command Mode
Stack Global Configuration
User Guidelines
No specific guidelines.
Examples
console(config)#stack
console(config-stack)#standby 2
2CSPC4.XModular-SWUM200.book Page 1588 Thursday, March 10, 2011 11:18 AM
