1396 Password Management Commands
no passwords strength-check
Parameter Description
This command does not require parameter descriptions.
Default Behavior
The password strength feature is disabled by default.
Command Mode
Global Configuration
User Guidelines
This command enables/disables enforcement of password strength checking
policy as configured by the following commands:
passwords strength minimum uppercase-letters
passwords strength minimum lowercase-letters
passwords strength minimum special-characters
passwords strength minimum numeric-characters
passwords strength max-limit consecutive-characters
passwords strength max-limit repeated-characters
passwords strength minimum character-classes
passwords strength minimum uppercase-letters
Use this command to enforce a minimum number of uppercase letters that a
password must contain. The valid range is 0–16. The default is 1. A minimum
of 0 means no restriction on that set of characters. Use the no form of the
command to reset the minimum uppercase letters to the default value.
Syntax
passwords strength minimum uppercase-letters
0–16
no passwords strength minimum uppercase-letters
2CSPC4.XModular-SWUM200.book Page 1396 Thursday, March 10, 2011 11:18 AM
