Password Management Commands 1401
passwords strength max-limit repeated-
characters
Use this command to enforce a maximum repeated characters that a
password should contain. If password has repetition of characters more than
the configured max-limit, it fails to configure. The valid range is 0-15. The
default is 0. A maximum of 0 means again disabling the restriction. Use the
no form of this command to reset the maximum repeated characters to the
default value.
Syntax
passwords strength max-limit repeated-characters
0-15
no passwords strength max-limit repeated-characters
Parameter Description
This command does not require parameter descriptions.
Default Behavior
The default value is 0.
Command Mode
Global Configuration
User Guidelines
This command has no user guidelines.
Example
console(config)# passwords strength max-limit repeated-characters 3
passwords strength minimum character-classes
Use this command to enforce a minimum number of character classes that a
password should contain. Character classes are uppercase letters, lowercase
letters, numeric characters and special characters. The valid range is 0-4. The
default is 0. If a value of 0 is configured then no character class checking is
2CSPC4.XModular-SWUM200.book Page 1401 Thursday, March 10, 2011 11:18 AM
