System Management Commands 1533
80
System Management Commands
This chapter explains the following commands:
asset-tag – show cut-through
mode
show system id
banner exec login-banner show interfaces
advanced firmware
show system
temperature
banner login member show ip interface
out-of-band
show tech-support
banner motd motd-banner show memory cpu show users
banner motd
acknowledge
movemanagement show nsfUse the
show nsf command
to show the status
of non-stop
forwarding.
show version
clear checkpoint
statistics
nsf show power-usage-
history
stack
cut-through mode ping show process cpu console(config-
stack)#stack-port
exec-banner reload show sessions standby
hostname set description show slot switch renumber
initiate failover slot show supported
cardtype
telnet
ip address show banner show supported
switchtype
traceroute
ip address none show boot-version show switch
ip address
{dhcp/bootp}
show checkpoint
statistics
show system
2CSPC4.XModular-SWUM200.book Page 1533 Thursday, March 10, 2011 11:18 AM
