584 Port Channel Commands
Syntax
lacp system-priority
value
no lacp system-priority
•
value
— Port priority value. (Range: 1–65535)
Default Configuration
The default system priority value is 1.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the system priority to 120.
console(config)#lacp system-priority 120
lacp timeout
Use the lacp timeout command in Interface Configuration mode to assign an
administrative LACP timeout. To reset the default administrative LACP
timeout, use the no form of this command.
Syntax
lacp timeout {long | short}
no lacp timeout
•
long
— Specifies a long timeout value.
•
short
— Specifies a short timeout value.
Default Configuration
The default port timeout value is long.
2CSPC4.XModular-SWUM200.book Page 584 Thursday, March 10, 2011 11:18 AM
