656 RADIUS Commands
•
auth-port-number
— Port number for authentication requests. (Range: 1 -
65535)
Default Configuration
The default value of the port number is 1812.
Command Mode
Radius mode
User Guidelines
The host is not used for authentication if set to 0.
User must enter the mode corresponding to a specific Radius server before
executing this command.
Example
The following example sets the port number 2412 for authentication
requests.
console(config)#radius-server host 192.143.120.123
console(config-radius)#auth-port 2412
deadtime
Use the deadtime command in Radius mode to configure the minimum
amount of time to wait before attempting to re-contact an unresponsive
RADIUS server. If a RADIUS server is currently active and responsive, that
server will be used until it no longer responds. RADIUS servers whose
deadtime interval has not expired are skipped when searching for a new
RADIUS server to contact.
Syntax
deadtime
deadtime
•
deadtime —
The amount of time that the unavailable server is skipped
over. (Range: 0-2000 minutes)
2CSPC4.XModular-SWUM200.book Page 656 Thursday, March 10, 2011 11:18 AM
