Filter
Top Products
25
2. Repositioning a Point Feature
If a point feature appears to be mislocated on the Map screen
or if you wish to make the position more accurate (by using
an external antenna, occupying point positions for more
time, etc.), do the following once you have arrived at the fea-
ture and the Selected screen showing all the feature’s at-
tributes is displayed:
- Press MENU, select the
Update Position option and press
ENTER.
If you press NAV and go back to the Map screen, you
will now see two features (one at the old position, the
other at the new position). To remove the feature's old
position, just move the map cursor so that the feature is
off the screen. When you move the cursor back to the
feature, only the new position will be visible.
3. Adding More Features and Attributes to the Job
If you want to add more features and descriptions to the ex-
isting job, you just have to record them exactly as you record
features into a new job.
4. Closing the Job
To close the job, all you have to do is open up another job or
turn the receiver off. To open another job, use the
Open Job
option after pressing the MENU button. You cannot acciden-
tally lose data with MobileMapper without opening the re-
ceiver and losing or damaging the internal memory card.
The Repositioning func-
tion only applies to point
features, not to line or
area features.
Selecting
Update Position