Filter
Top Products
114
Installing a Memory Card
To remove and insert an SD card:
- Turn the MobileMapper off
- Remove the battery door and then the AA batteries
- To remove the card, push the card slightly towards the
top of the MobileMapper. You will feel a slight click
which is the locking mechanism disconnecting and then
you will feel the memory card pushing against your fin-
ger. Allow the SD card to slide back towards the battery
compartment. Now carefully continue to slide the mem-
ory card out of the channel it is in and lift it out.
- To install the card, hold it with two fingers with the label
facing you. Place the top of the SD card in the channel
provided in the battery compartment. Carefully push the
SD card towards the top of the unit until you feel it lock
into place. Do not force the SD card.
- Reinstall the batteries into the battery compartment. Be
sure to observe the proper polarity.
- Replace the battery compartment door.
- Turn on the MobileMapper unit.
MobileMapper ships
with a 16 MB SD card,
but you can use SD cards
of any size. The addition
of the memory card to
your MobileMapper will
increase the amount of
data that can be
uploaded to it from CD-
ROM products