Filter
Top Products
Magellan NAV 6000 35
Creating a GOTO Route to the Cursor Position
Press GOTO from any screen. The Map screen appears.
Move the cursor over the desired destination point and press
ENTER.
If no waypoint exists at the cursor position, the MARK
CURSOR POSITION window appears.
Use the CURSOR KEY and ENTER to modify the name,
type and description, if desired, and press DONE.
Creating a GOTO route automatically deletes any
previous GOTO route and deactivates any previ-
ously active route. If the previous GOTO route
was a GOTO MOB, you must confirm to delete
it.
A solid line shows the GOTO route created from the present
position to the cursor position.
Creating a MOB Route
GOTO
MOB
The MOB, or Man Over Board, function allows you to
instantly create a GOTO route to the GPS position at the
time you pressed the GOTO key and MOB softkey.
Press GOTO from any screen. The Map screen appears
and the active softkeys are LIST, NEARST, FIND and
MOB.
Press the MOB softkey.
A GOTO MOB has been created to the position at which
you pressed the MOB softkey.
When a GOTO MOB has been created, it remains
in memory until you set another route or GOTO.
A confirmation window then appears.
Deleting a GOTO Route
Press GOTO from any screen. The Map screen appears
and the active softkeys are LIST, NEARST, FIND and
MOB. The message window shows “Enter: Goto cursor
pos Quit: exit/clear.”
GOTO
Move cursor
to destination
Modify or
Accept Default
Data
ENTER
DONE
Only if destination is not an
existing waypoint
GOTO QUIT
Confirm
Delete