Filter
Top Products
74
Received Invalid Waypoint
—
A waypoint was received during upload transfer that
has an invalid identifier.
Receiver Failed
—
A failure in receiver hardware has been detected. If this message
persists, do not use the unit and take it to an authorized dealer for repair.
Route is Full
—
You have attempted to add more than 50 waypoints to a route.
Route Waypoint Deleted
—
A route waypoint entered does not exist in the database
and has been deleted from the route.
Searching the Sky
—
The GPSMAP is in searching the sky for almanac data or the unit
is in AutoLocate
TM
mode.
Stored Data Lost
—
All waypoints, routes and almanac data has been lost due to
internal battery failure.
Timer Expired
—
The countdown timer has expired.
Track Memory Full
—
The track memory is full and no additional track plot will be
recorded until the track memory has been cleared or set to wrap mode (see page 59).
Transfer Completed
—
The receiver is finished uploading or downloading
information to the connected device.
User Card Operation Complete
—
The user card data transfer has been completed.
Waypoint Exists
—
The waypoint name you’re entering already exists in memory.
Waypoint Memory Full
—
You have used all available waypoints in the GPSMAP unit.
SECTION
D
APPENDIX
Messages
215225manb.qxd 4/27/00 9:22 AM Page 74