Filter
Top Products
The GPSMAP system uses an on-screen
message field to alert you to important
information. Whenever a message appears,
press the C key to confirm the message.
There are two types of messages: temporary
messages and condition messages. Temporary
messages are cleared from the message page
after viewing, while condition messages
remain in the message window until the
condition has been resolved.
To view the message window, press the
MESSAGES softkey from the Auxiliary
Options Window. Pay careful attention
to all messages for your own safety.
72
Alarm Clock
—
The alarm clock time has been reached and the alarm has sounded.
Anchor Drag Alarm
—
You have drifted out of the specified distance range.
Antenna Input Shorted to Ground
—
The GPSMAP has detected a short on the
antenna connection. Check the connection, combiner (if used) and cable(s).
Modifying cables (shortening or changing connectors) can also cause this condition if
done improperly and may void your warranty.
Approaching
—
You are less than one minute away from reaching a destination way-
point at your present speed over ground.
Arrival At
—
You are within the distance specified on the timer/alarm setup from
reaching your final destination waypoint.
Can’t Change Active Waypoint
—
You have attempted to change the ‘active to’ or
‘active from’ waypoint. Clear the active route or GOTO before making your changes.
Card Format Not Recognized
—
The cartridge you have inserted is not readable by
the GPSMAP system and may be damaged. Reinsert the cartridge and make sure it is
properly installed.
Database Memory Failed
—
The built-in 64 n.m. database has failed. See an autho-
rized service center for repair.
Degraded Accuracy
—
The accuracy of the GPSMAP has been degraded beyond
500 meters due to poor satellite geometry or data quality. You should check other
navigational sources to verify the position indicated.
Display ROM Failed
—
The graphic processor read-only memory has failed and the
unit is no longer operable. See an authorized GARMIN service center for repair.
Max Calibration Is 5000mt (16,400 ft)
—
You have exceeded the maximum possi-
ble map calibration.
SECTION
D
APPENDIX
Messages
215225manb.qxd 4/27/00 9:22 AM Page 72