Filter
Top Products
84
To switch back to using the iFINDER's internal antenna (or to use an
optional external active antenna), be sure to turn off this command.
From the Satellite Status page, press
MENU|↓ to EXT PASSIVE ANT. Press
ENT to uncheck the box.
GPS Simulator
The GPS simulator lets you use the unit as if you were navigating out-
doors. You can set the starting location in latitude/longitude (Starting
Position) or from a stored waypoint, map place or POI location (Select
Starting Waypoint). You can steer your position on the map by using
the arrow keys (
STEER W/ ARROWS) or by setting the track and speed in
the boxes provided on simulator screen.
To get to the GPS Simulator:
1. Press
MENU|MENU|↓ to GPS SETUP|ENT.
2. Press ↓ to
GPS SIMULATOR|ENT.
GPS Setup Menu (left); GPS Simulator Menu (right).
Choose the desired settings, then turn on the simulator by highlighting
the
SIMULATOR ON box and pressing the ENT key. Press EXIT to close this
menu. A message appears periodically, reminding you the simulator is on.
To turn off the simulator, repeat the above steps or turn off the unit.
While in simulator mode, you can press
EXIT to clear the steering and
speed boxes from the screen while continuing the simulation. This will
allow you to use the map cursor during a simulation. To turn on the
steering and speed boxes again, return to the GPS Simulator menu,
select the
STEER WITH ARROWS command, and press ENT. Press EXIT re-
peatedly to return to the previous page.
Simulating Trail or Route Navigation
In Simulator mode, your unit can automatically follow a trail or route
without manual steering if you use these steps: