Filter
Top Products
126
iFINDER
HUNTc Quick Reference
Start outdoors, with a clear view of the open sky. As you practice, try
navigating to a location a few blocks away. Navigation in too small a
space, like a backyard, will constantly trigger arrival alarms.
1. Install two AA batteries (and MMC card if desired) in the battery
compartment on back of case. (See installation on page 11.)
2. To turn on the iFINDER HUNTc, press and release the
PWR key.
3. Opening screen displays map of North America at the 4,000-mile
zoom range. Rotate through the two main Page screens (Map Page and
Compass Page) by repeatedly pressing
PAGES.
4. Wait while unit locates satellites and calculates current position. Flash-
ing question mark or data boxes indicate a position has not been deter-
mined. Position calculation takes an average of one minute or less under
clear sky conditions (unobstructed by terrain or structures.) When position
is found, a tone sounds, a position-acquired message appears, data boxes
stop flashing and the flashing question mark disappears.
5. With position acquired, the Map Page shows your location on the
map in a bird's eye view of the earth. You can move around the map by:
Zoom in closer to see greater detail: press
ZIN (zoom in key.)
Zoom out to see more area, less detail: press
ZOUT (zoom out key.)
Scroll map north, south, east or west using arrow keys ↑ ↓ → ←.
To stop scrolling and return to current position on map, press
EXIT key.
6. Set a Vehicle waypoint at your current position so you can navigate
back to your vehicle: press
ENT and use the ↓ ↑ to highlight VEHICLE from
the waypoint list, then press|
ENT|ENT. Waypoint Vehicle(1) will ap-
pear on the map.
7. Zoom/scroll map to find a nearby object or location. Use arrow keys to
center the cursor crosshairs over the map object or location.
8. To navigate to the selected location: press
MENU, select GO TO CURSOR and
press
ENT|EXIT. Follow steering arrow on Map Page or compass bearing
arrow on Compass Page.
9. At destination, Arrival Alarm goes off. To clear it, press
EXIT. To
Cancel navigation: press
MENU|↓ to CANCEL NAVIGATION|ENT|← to
YES|ENT.
10. Navigate back home: Zoom/scroll map and use arrow keys to center
cursor crosshair over waypoint Vehicle (1). Press
MENU, select GO TO
CURSOR and press ENT|EXIT.
11. Back home, Arrival Alarm goes off; press
EXIT. Cancel navigation:
press
MENU|↓ to CANCEL NAVIGATION|ENT|← to YES|ENT.
12. To turn off the iFINDER, press and hold
PWR key for three seconds.