Filter
Top Products
29
iFINDER
HUNTc™ Easy Mode Quick Reference
Start outdoors, with a clear view of the open sky. As you practice, try
navigating to a location a few blocks away. Navigation in too small a
space, like a backyard, will constantly trigger arrival alarms.
1. Install two AA batteries and an MMC card in the battery compart-
ment on back of case. (See installation details beginning on page 11.)
2. To turn on the iFINDER, press and release the
PWR key.
3. Opening screen displays map of North America at the 4,000-mile
zoom range. Rotate through the four main Page screens (Map Page,
Satellite Status Page, Compass Page and Navigation Page) by repeat-
edly pressing
PAGES key.
4. Wait while unit locates satellites and calculates current position. Process
is visible on Satellite page. This takes an average of 1 minute or less under
clear sky conditions (unobstructed by terrain or structures.) When the unit
acquires position, a tone sounds and a position acquired message appears.
5. With position acquired, press the
PAGES key to display the Map
Page, which shows a bird's eye view of the earth. You can move around
the map by:
Zooming in closer to see greater detail: press
ZIN (zoom in key.)
Zooming out to see more area with less detail: press
ZOUT (zoom
out key.)
Scroll map north, south, east or west using arrow keys ↑ ↓ → ←.
To stop scrolling and return to current position on map, press
EXIT key.
6. Set Home waypoint at your current position so you can navigate back
it: press
ENT|ENT.
7. Zoom/scroll map to find a nearby object or location. Use arrow keys to
center cursor crosshairs over the map object or location.
8. To navigate to the selected location: press
MENU|ENT|EXIT. Follow
steering arrow on Map Page or compass bearing arrow on Navigation Page.
9. At destination, Arrival Alarm goes off. To clear it, press
EXIT. To
Cancel navigation: press
MENU|↓ to CANCEL NAVIGATION|ENT|. A message
will appear asking if you want to cancel navigation. Select
YES and
press
ENT.
10. Navigate back home by
GO HOME or NAVIGATE TRAIL. To Go Home:
press
FIND|ENT, then follow navigation arrows. To Navigate Trail:
press
MENU|↓ to NAVIGATE TRAIL|ENT. Wait while route is calculated,
then follow the navigation arrows.
11. Back home, when Arrival Alarm goes off, press
EXIT. To Cancel
navigation: press
MENU|↓ to CANCEL NAVIGATION|ENT| ←| YES| ENT.
12. To turn off the iFINDER, press and hold
PWR key for three seconds.