Filter
Top Products
56
The Transfer My Data submenu asks if you want to save data to the
MMC or load data from the MMC into iFINDER's memory.
2. The Transfer My Data menu includes a message which tells you if an
MMC is present or not. If no MMC is present, you must first insert a
card into the iFINDER in order to activate the Load or Save commands.
To load data from the MMC to iFINDER: press → to
LOAD|ENT.
3. Loading: There may be more than one GPS Data File (*.USR) on the
card. To select a file, press
ENT to activate the selection box, use ↓ or ↑ to
highlight the file, then press
ENT to accept the selection. Next, press ↓ to
LOAD|ENT. The unit will display a completion message when the data
transfer is finished. To return to the Page view, press
EXIT|EXIT|EXIT.
Navigate
Navigation is one of the most powerful reasons for owning an iFINDER.
With the navigation options available you can get accurate information
about where you want to go, how to get there, how long it will take and
other useful trip information.
Navigate Back Home
You can navigate to the Home waypoint created in Easy Mode, but you
must use Advanced Mode's procedure for navigating to a waypoint. See
the entry: Navigate to a Waypoint later in this section.
Navigate Back to Man Overboard Waypoint
This unit has a man overboard feature that shows navigation data to
the location where the feature was activated. To activate it, press the
ZOUT and ZIN keys at the same time. Your position at the time these
keys are pressed is used as the man-overboard position. The unit auto-
matically begins navigating to the MOB waypoint. For further details,
see this subject in Sec. 3, Easy Mode Operation.