Filter
Top Products
Platform Installations and Upgrades
Installing or Removing a Hard Drive
Up to two hot-swappable SCSI drives can be installed in your chassis. It is not necessary
to remove the chassis cover to add or replace a hot-swap hard drive. It is necessary to
remove the front bezel from the chassis.
CAUTION
The Intel
®
Carrier Grade Server TIGI2U does not support all hard
drives. To see a list of validated manufacturers and hard drive
types, see:
http://support.intel.com/support/motherboards/server/TIGI2U
Installing a Hard Drive
1. Remove the front bezel. For instructions, see “Removing the Front Bezel.”
2. Press in on the green latch on the front of the hard drive carrier (see letter “A”).
3. Pull out on the black lever to slide the carrier from the chassis (see letter “B”).
B
A
TP01662
Figure 22. Removing Hard Drive Carrier from Chassis
4. Remove the hard drive from its wrapper and place it on an antistatic surface.
5. Set any jumpers and/or switches on the drive according to the drive manufacturer’s
instructions.
6. With the drive circuit-side down, position the connector end of the drive so that it is
facing the rear of the drive carrier (see letter “A”).
Intel
®
Carrier Grade Server TIGI2U User Guide
46