Raymarine GPS navigation GPS Receiver User Manual


 
When-is pressed the route sequence
mode,
will be ON. The route
number will be displayed in the left corner of the waypoint information bar
on the POS, NAV, or
CD1
screens and the first point of the route plan
becomes your initial destination, unless you happen to already be at the first
point of the route.
While you are following the route plan you may press
themlkey
anytime to bypass the next point in the route plan.
Turning the Route OFF
The route plan can be conveniently turned OFF anytime by pressing the
the FOLLOW ROUTE screen press the
One other method of turning the route sequence to OFF is a bit indirect but
if you press
thdmlkey
to select any waypoint that is not part of the route
plan, or press
ml,
OJm
, the route will be turned OFF.
3.9.3 Editing Route Plans
The EDIT ROUTE mode is used to
INSERT
or
DELETE
waypoints in a route
plan or to ERASE a route plan in its’ entirety.
Press the
/ROUTE/51
key. Press
thelm[
softkey.
when
the EDIT ROUTE
Selection screen appears, select the route number you
1
EDIT ROWE
wish to edit.
Press//[
I
SELECT ROUTE NUMBW
On the EDIT ROUTE screen the route legs can be
123@5
examined and the bearing and distance of the high-
m
lighted leg of the route plan displayed. If changes are
fi
ERASEROUTE
+
necessary, you can insert or delete waypoints in the
B
e
legs in a route by performing the following key opera-
1
MESS
CLEANToEaT
tions:
The EDIT ROUTE display shows the Route # and
the leg containing the first two
waypoint
#‘s
in the
route. To see other waypoints in the legs of the route,
of interest in the highlighted block to check the bearing
and distance.
OPERATION
3-33