Filter
Top Products
On the
WAYPOINT SF
screen, confirm that the number shown under
ERASE
WAYPOMT
is correct. Also verify that the Waypoint Protection feature for
the selected
waypoint
is OFF. Press the
1
ERASE
WAYPOINT~
soflkey.
The
waypoint will be erased.
WARNING !
Make sure that the waypoint to be erased is NOT selected as your
current destination. Only waypoints protected “manually” cannot
be accidentally erased.
C. Copying Waypoints
Waypoints can easily be transferred from one memory location to another
using the COPY feature. To Copy waypoints: Press
them
softkey on the
Waypoint
List. On the Waypoint- SF menu press
ICOPYIMEASURE
WPTSl
softkey.
When the
COPY/MEAS.
screen appears, press
theI=
softkey.
Then type the waypoint # (from) and
press-1
Then press the
waypoint
# (to) and press
(ENTERI
again.
Example:
[=I
34-1
1, 5,
(ENTEd
.
Wpt
#3
is now copied into wpt
#15.
D. Measuring between Waypoints
You can easily measure the bearing and range
between any two waypoints stored in memory
by pressing
the/
COPY
/
MEASURE
WPTS~
soflkey
on the WAYPOINT
-
SF screen.
when the
COPYhIEAS.
WAYPOINTS
screen appears, press thelMEAS.lsoft-
key. Then type the number of the “FROM” waypoint and
-1
followed
by the number of the “TO” waypoint. Press
thel[
key.
The calculated
bearing and range will then be displayed.
If you want to measure additional points, press
the-1
softkey
again.
The Fr and To digits will clear and you may re-enter a new pair of numbers.
Press
Fj?[for
the new Bearing/Range calculation.
Pressmjwhen
you are finished to return to the Waypoint List.
OPERATION 3-26
.
--:-.
--a-