Filter
Top Products
Enter the waypoint Longitude coordinates by typing the numeric value.
_._...
Begin with a
“0”
if the Longitude is less than 100’. Press
1-1
when the
value is correct
anqn\again
if the direction is displayed correctly. If
the indicated direction is incorrect, press the softkey for
“E”
or
“w”.
,
Example:
Press
0,8,2,
1,
0,2,
S,Im(ENTER[
Long. = W 82’ 10.25’
When
m[
is pressed, a "CALCULATING" message appears on the
display while the unit is storing the new
waypoint
and then the screen
changes back to the Waypoint Directory.
If
you want to enter another waypoint, press
IENTER NEW WAYPOINT?I.
This key returns you to the NAME WAYPOINT page and advances the
waypoint memory number to next available memory. To designate a particu-
lar memory number to continue waypoint entries,
press1
ENTER
WPT
NO.
1
If you want to recheck the new entry, press1
GOTO
WAYPOINT
LISA
key.
-
Press
-1
if you are finished. This will return you back to the previous
display mode.
3.6.4.2. Storing by
TDs
To enter the waypoint coordinates in Loran-C Time Differences, on the
STORE WAYPOINT menu press
them
softkey.
Enter the TD 1 coordinate by typing in the nu-
IS-IWRE
WAYPOINT TJD
1
merit value using all six digits. Press
-J
~a02
GRI
=
9960
when the
TDl
value is OK.
m,
26238.4
--m-m
-
Example: Press 2,7, 1, 0,
1,5,
-1.
lD2
om!x!.o_
TDl =
27101.5~s
Enter the TD2 coordinate by typing the numeric
value in using six digits. Press
1-1
when the TD2 value is OK.
Example: Press 4,4,2, 1, 0,2,
-1
TD2 =
44210.2~s
When-1
is pressed,
the unit will now calculate a “corrected” L/L
to store as the waypoint. During the calculation process the unit
will display a
"
CALCULATING
"
message on the screen. Please wait for
the message to disappear before continuing.