Filter
Top Products
Reference Manual
00809-0100-4811, Rev CA
February 2006
Rosemount 3300 Series
5-2
ERROR MESSAGES The display can also be used for presentation of software errors. The upper
row shows error codes and the lower row shows 'ERROR'.
Figure 5-2. Presentation of error
messages
The following errors can be displayed:
See also “Errors” on page 6-22.
ALARM AND WRITE
PROTECTION
When mounting the Integral Display panel it is important that the Alarm and
Write Protection switches on the transmitter mother board are correctly set.
Make sure that the Alarm switch is in the HIGH position and the Write
Protection switch is in the OFF position, see Figure 5-3. See also Section 3:
Before You Install for more information.
Figure 5-3. Alarm and Write
Protection switches.
Once the mother board positions are set, then the display positions become
the master.
Code Error
CNFIG Invalid Configuration
00001 Ram Failure
00002 ROM Checksum
00006 Waveform Acquisition Failure
00007 EEprom Factory Checksum
00008 EEprom User Checksum
00010 Software Error
00013 Probe Failure
Error code
“ERROR”
DISPLAY ERROR
Motherboard
SWITCH_WRP_ALARM_DISPLAY