952 IPv6 PIM Commands
If no configured/elected BSR’s exist on the router, the following message is
displayed:
No BSR’s exist/learned on this router.
show ipv6 pim interface
Use the show ipv6 pim interface command to display the PIM interface
status parameters. If the interface number is not specified, this command
displays the status parameters of all the PIM-enabled interfaces.
Syntax
show ipv6 pim interface [ vlan
vlan-id
]
Parameter Description
Default Configuration
There is no default configuration for this command.
Command Mode
User EXEC, Privileged EXEC modes
User Guidelines
There are no user guidelines for this command. Field descriptions are shown
in the table below.
Parameter Description
vlan-id A valid VLAN ID for which multicast routing has been enabled.
Field Description
Mode Active PIM protocol
Interface Interface number
Hello Interval Hello interval value
Join-prune Interval Join-prune interval value
DR Priority DR priority configured on this interface
2CSPC4.XModular-SWUM200.book Page 952 Thursday, March 10, 2011 11:18 AM
