632 QoS Commands
redirect
Use the redirect command in Policy-Class-Map Configuration mode to
specify that all incoming packets for the associated traffic stream are
redirected to a specific egress interface (physical port or port-channel).
Syntax
redirect
interface
•
interface
— Specifies any valid interface. Interface is Ethernet port or
port-channel (Range: po1-po32 or gi1/0/1-gi1/0/24)
Default Configuration
This command has no default configuration.
Command Mode
Policy-Class-Map Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example shows how to redirect incoming packets to port 1/0/1.
console(
config-policy-classmap)#redirect 1/0/1
service-policy
Use the service-policy command in either Global Configuration mode (for all
system interfaces) or Interface Configuration mode (for a specific interface)
to attach a policy to an interface. To return to the system default, use the no
form of this command.
Syntax
service-policy {in|out}
policymapname
no service-policy {in|out}
policymapname
2CSPC4.XModular-SWUM200.book Page 632 Thursday, March 10, 2011 11:18 AM
