570 Port Aggregator Commands
show bridge address-table
Use the show bridge address-table command to show the MAC address table
for a particular aggregator group.
[port-aggregator group <Group id>
is an
optional parameter in the command, and if not specified, it shows all the
MAC entries in all the Groups.
Syntax
show bridge address-table
[port-aggregator group < GroupId >]
•
GroupId
— Port Aggregator group identifier. (Range: 1-8 or 1-72) On a
standalone switch, it is up to 8. On a stack, it is 1 to (6 x<number of units
in stack). For a stack of 12 units it is 1-72.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
console#show bridge address-table port-aggregator
group 2
Aggregator Group: 2
Aging time is 300 Sec
Vlan Mac Address Port Type
-------- --------------------- ------ ---------------
-----
3 0006.2932.814D 1/g2 Static
1001 0006.2932.814B 1/g17 Static
2CSPC4.XModular-SWUM200.book Page 570 Thursday, March 10, 2011 11:18 AM
