IPv6 Multicast Commands 1055
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 pimsm register-threshold 250
ipv6 pimsm rp-address
Use the ipv6 pimsm rp-address command to statically configure the RP
address for one or more multicast groups. The optional keyword override
indicates that if there is a conflict, the RP configured with this command
prevails over the RP learned by BSR. Use the "no" form of this command to
remove the RP address for one or more multicast groups.
Syntax
ipv6 pimsm rp-address
rp-address group-address/prefixlength
[ override ]
no ipv6 pimsm rp-address
•
rp-address
—An RP address.
•
group-address
—The group address to display.
•
prefixlength
—This parameter specifies the prefix length of the IP address
for the media gateway. (Range: 1–32)
Default Configuration
There are no static RP addresses configured by default.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 pimsm rp-address 2001::1
ff1e::/64
2CSPC4.XModular-SWUM200.book Page 1055 Thursday, March 10, 2011 11:18 AM
