A SERVICE OF

logo

462 IP Addressing Commands
console(config-if)#
ip address (Out-of-Band)
Use the ip address command in Interface Configuration mode to set an IP
address for the service port. Use the no form of this command to return the ip
address configuration to its default value.
Syntax
ip address {
ip-address
{
mask
|
prefix-length
} | dhcp}
no ip address
Parameter Description
Default Configuration
The out-of-band interface (service port) obtains an IP address via DHCP by
default.
Command Mode
Interface (Out-of-Band) Configuration mode
Parameter Description
ip-address Specifies a valid IP address.
mask Specifies a valid subnet (network) mask IP address.
prefix-length The number of bits that comprise the IP address prefix. The
prefix length must be preceded by a forward slash (/). (Range: 1-
30 bits)
dhcp Obtain the service port address via DHCPv4.
2CSPC4.XModular-SWUM200.book Page 462 Thursday, March 10, 2011 11:18 AM