Address Table Commands 271
•
max-addr
— The maximum number of addresses that can be learning on
the port. (Range: 0-600)
Default Configuration
The default value for this command is 100.
Command Mode
Interface Configuration (gigabitethernet, port-channel, tengigabitethernet)
mode
User Guidelines
This command has no user guidelines.
Example
The following example shows using this command in Ethernet Interface
Configuration mode.
console(config-if-1/0/3)# port security max 80
show mac address-table multicast
Use the show mac address-table multicast command in Privileged EXEC
mode to display Multicast MAC address table information.
Syntax
show mac address-table multicast [vlan
vlan-id
]
[address {
mac-multicast-
address
|
ip-multicast-address
}] [format {ip | mac}]
•
vlan_id
— A valid VLAN ID value.
•
mac-multicast-address
— A valid MAC Multicast address.
•
ip- multicast-address —
A valid IP Multicast address.
•
format
—
Multicast address format. Can be
ip
or
mac
.
Default Configuration
If format is unspecified, the default is mac.
2CSPC4.XModular-SWUM200.book Page 271 Thursday, March 10, 2011 11:18 AM
