Ethernet Configuration Commands 403
•
groupid-
-Identifies which group this port will be protected in. (Range: 0-2)
Default Configuration
No protected switchports are defined.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example configures Ethernet port 1/0/1 as a member of
protected group 1.
console(config)#interface gigabitethernet 1/0/1
console(config-if-1/0/1)#switchport protected 1
switchport protected name
Use the switchport protected name command in Global Configuration mode
to adds the port to the protected group 1 and also sets the group name to
"protected".
Syntax
switchport protected
groupid
name
name
no switchport protected
groupid
name
•
groupid
— Identifies which group the port is to be protected in.
(Range: 0–2)
•
name
— Name of the group. (Range: 0-32 characters)
Default Configuration
This command has no default configuration.
2CSPC4.XModular-SWUM200.book Page 403 Thursday, March 10, 2011 11:18 AM
