OSPFv3 Commands 1157
Syntax
area
areaid
virtual-link
neighbor
hello-interval
seconds
no area
areaid
virtual-link
neighbor
hello-interval
•
areaid
— Valid OSPFv3 area identifier.
•
neighbor
— Router ID of neighbor.
•
seconds
— Hello interval. (Range: 1-65535)
Default Configuration
10 is the default value for
seconds
.
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures a hello interval of 20 seconds for the OSPF
virtual interface on the virtual interface identified by area 1
and its neighbor.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 virtual-link 2 hello-
interval 20
area virtual-link retransmit-interval
Use the area virtual-link retransmit-interval command in Router OSPFv3
Configuration mode to configure the retransmit interval for the OSPF virtual
interface on the virtual interface identified by
areaid
and
neighbor
.
Syntax
area
areaid
virtual-link
neighbor
retransmit-interval
seconds
no area
areaid
virtual-link
neighbor
retransmit-interval
•
areaid
— Valid OSPFv3 area identifier.
2CSPC4.XModular-SWUM200.book Page 1157 Thursday, March 10, 2011 11:18 AM
