A SERVICE OF

logo

Multicast Commands 1031
Command Mode
Global Configuration mode
User Guidelines
Only one of sparse or dense mode can be configured on a router.
Example
console(config)#ip pim sparse
ip pim ssm
Use the ip pim ssm command in Global Configuration mode to
administratively configure PIM source specific multicast range of addresses
for IP multicast routing. Use the no form of this command to remove
configured ranges of addresses from the router.
Syntax
ip pim ssm {default |
group-address group-mask
}
no ip pim ssm {default |
group-address group-mask
}
Parameter Description
Default Configuration
There are no group addresses configured by default.
Command Mode
Global Configuration mode
Parameter Description
default Defines the SSM range access list to 232/8.
group-address An IP multicast group address.
group-mask An IPv4 mask in a.b.c.d form where a, b, c and d range from 0-
255.
2CSPC4.XModular-SWUM200.book Page 1031 Thursday, March 10, 2011 11:18 AM