1030 Multicast Commands
Parameter Description
Default Configuration
None - the router does not advertise itself as an RP candidate by default.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ip pimsm rp-candidate vlan 10
239.1.0.0 255.255.0.0
ip pim sparse
Use the ip pim sparse command in Global Configuration mode to
administratively configure PIM sparse mode for IP multicast routing. Use the
no form of this command to disable PIM sparse mode. This command
replaces the ip pimsm command.
Syntax
ip pim sparse
no ip pim sparse
Default Configuration
PIM not enabled by default.
Parameter Description
vlan-id A valid VLAN identifier with multicast routing enabled.
group-address A valid multicast group address.
group-mask A mask indicating the range of multicast groups for which the
router should advertise itself as an RP-candidate.
2CSPC4.XModular-SWUM200.book Page 1030 Thursday, March 10, 2011 11:18 AM
