252 ACL Commands
User Guidelines
An optional sequence number may be specified to indicate the order of this
access-list relative to the other access-lists already assigned to this interface
and direction. A lower number indicates higher precedence order. If a
sequence number already is in use for this interface and direction, the
specified access-list replaces the currently attached access list using that
sequence number. If the sequence number is not specified for this command,
a sequence number is selected that is one greater than the highest sequence
number currently in use for this interface and direction.
This command specified in Interface Configuration mode only affects a
single interface.
Example
The following example assigns a MAC access group to port 1/0/1 with the
name DELL123.
console(config)#interface 1/0/1
console(config-if-1/0/1)#mac access-group DELL123
mac access-list extended
Use the mac access-list extended command in Global Configuration mode to
create the MAC Access Control List (ACL) identified by the
name
parameter.
Syntax
mac access-list extended
name
no mac access-list extended
name
•
name
— Name of the access list. (Range: 1-31 characters)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
2CSPC4.XModular-SWUM200.book Page 252 Thursday, March 10, 2011 11:18 AM
