400 Ethernet Configuration Commands
storm-control broadcast
Use the storm-control broadcast command in Interface Configuration mode
to enable broadcast storm recovery mode for a specific interface. If the mode
is enabled, broadcast storm recovery is active, and if the rate of L2 broadcast
traffic ingressing on an interface increases beyond the configured threshold,
the traffic will be dropped. Therefore, the rate of broadcast traffic will be
limited to the configured threshold.
Syntax
storm-control broadcast [level |
rate
]
no storm-control broadcast
• level— The configured rate as a percentage of link-speed.
•
rate
— The configured rate in kilobits per second (kbps). (Range: 0-100)
Default Configuration
The default value is 5.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
console(config-if-1/0/1)#storm-control broadcast
level 5
storm-control multicast
Use the storm-control multicast command in Interface Configuration mode
to enable multicast storm recovery mode for an interface. If the mode is
enabled, multicast storm recovery is active, and if the rate of L2 multicast
traffic ingressing on an interface increases beyond the configured threshold,
the traffic will be dropped. Therefore, the rate of multicast traffic will be
limited to the configured threshold.
2CSPC4.XModular-SWUM200.book Page 400 Thursday, March 10, 2011 11:18 AM
