Filter
Top Products
132
Performance Mode
TON Other (Tone Other)
You can set Pitch Bend Range and Velocity Sensitivity
parameters for each Part.
These screens are not available for the A/D Input Part.
Part 1 to 16
Plug-in 1/2 Part
Multi Plug-in Part
Phrase Clip Part
Drum Voice Part
■ Pitch Bend
Set the amount (in semitones) by which the Voice
pitch changes when the Pitch Bend Wheel is moved.
For example, a Lower setting of -12 means that the
pitch of the Voice drops by up to an octave when the
Pitch Bend Wheel is moved downwards. An Upper
setting of +12 means that the pitch of the Voice
rises by up to an octave when the Pitch Bend Wheel
is moved upwards.
The Lower parameter is only available for Normal
Voice Parts (Parts 1 to 16).
❏ Settings:
Lower (Left):
-48 ~ 0 ~ +24
Upper (Right):
-48 ~ 0 ~ +24 (or –24 ~ 0 ~ +24 for Plug-in 1/2 and
Multi Plug-in Parts)
■ VelDepth-Offset (Velocity Sensitivity Depth/Offset)
Set the velocity sensitivity and velocity offset for
each Part.
❏ Settings:
VelDepth (Velocity Sensitivity): 0 ~ 127
Offset (Velocity Offset): 0 ~ 127
VelDepth (Velocity Sensitivity Depth)
As illustrated below, a large setting will cause large changes
in velocity when you play the keyboard.
Changes to velocity curve according to VelDepth
(with offset set to 64)
Offset=64
Received Velocity
Velocity at
tone generator
Depth=64
Offset=64
Depth=32
Offset=64
Depth=0
Offset=64
Depth=127
Offset=64
TONíOther) Pitch Bend VelDepth-Offset
PartP1 +12 127 64
TONíOther) Pitch Bend VelDepth-Offset
Part01 -12 - +12 127 64
Offset (Velocity Offset)
As illustrated below, the velocity will be increased by
the specified amount.
Changes to velocity curve according to VelDepth
(with offset set to 64)
Part Layer
You can set various MIDI parameters for each Part,
including MIDI Receive Channel, Arpeggiator switch,
note limit and velocity. These parameters are largely
used when layering multiple Parts. The following four
screens are available.
LYR Mode (Layer Mode)
LYR Limit (Layer Limit)
LYR Tune (Layer Tune)
LYR Out (Layer Out)
LYR Mode (Layer Mode)
You can set the method by which each Part is output.
The parameters will vary according to the Part selected.
Part 1 to 16
Plug-in 1/2 Part
Phrase Clip Part
Drum Voice Part
A/D Input Part
Multi Plug-in Part
LYRíMode) RcvCh
PartAD 1
LYRíMode) Arp Layer RcvCh
Part01 on off 1
LYRíMode) Mode Arp Layer RcvCh
Part01 poly on off 1
Offset=+96
Offset=-32
Offset=127
Offset=64
Velocity=1
Received
Velocity
Velocity at
tone generator
Depth=64
Offset=64
Depth=64
Offset=32
Depth=64
Offset=96
Depends on
offset
Depends on
offset