Filter
Top Products
Basic functions 3-7
JJM 18 05 16/00 Last amend: November 1999 – NAS
General navigation menus (continued)
Calibration settings
Sometimes the vehicle position shown
on the map display may not be correct.
This can occur, for example, if the
vehicle has been moved on a trailer or by
ferry. If the new position is not found
correctly by the system, follow the
calibration procedure described as
follows.
Select the calibration item required:
Relocate
– The map showing the current
vehicle position is displayed.
The screen shows ‘Adjust Position’. Use
the Cursor control to move the
Navigation symbol as required and press
Enter.
The screen shows ‘Adjust Direction’. Use
the Cursor control (Left/Right) to adjust
the vehicle heading as required and press
Enter. The screen briefly shows
‘Relocation complete’.
Distance calibration
– This should only
be necessary if wheel/tyre sizes have
been changed. The screen shows ‘Press
ENTER to start calibration or F4 to
cancel’. Drive the vehicle as normal.
There are no special requirements for
distance calibration.
Units selection
The screen shows the currently selected
option. The options available are as
follows:
Units
– Miles/Kilometres.
Use the Cursor control to select the
required option (Left/Right). Press Enter
to confirm.
JOL.319
JOL.205