Filter
Top Products
3-4 Basic functions
JJM 18 05 16/00 Last amend: November 1999 – NAS
Getting started (continued)
Quick points of interest (Q-POI)
The screen shows a list of three
commonly used POI classes. Select the
class required and press Enter. The
screen shows a list of the three nearest
points in the selected class, see
Q-POI
selection.
Q-POI selection
Select the point required and press
Enter. The screen shows ‘Set as?
F1: Dest. F2: Mem. F3: WayPt.’. Select
the item required:
F1 (Dest.)
– A route to the selected
point of interest is calculated, see
Route
calculation
on page 6-1.
F2 (Mem.)
– The screen briefly shows
‘Point stored’.
F3 (WayPt.)
– The screen briefly shows
‘Point stored’. The point is stored as the
last point in the list of way points. If the
vehicle is under guidance, the way point
is added to the calculated route.
JOL.665
JOL.315