Filter
Top Products
Basic functions 3-3
JJM 18 05 16/00 Last amend: November 1999 – NAS
Getting started (continued)
Setting of points
After scrolling the map, the following
functions are available:
F1 (Dest.)
– Selects the map location
under the cross-wire marker as a
destination, see
Route calculation
on
page 6-1.
F2 (Mem.)
– Selects the map location
under the cross-wire marker as a
memory point. The screen briefly shows
‘Point stored’.
F3 (Heading)
– Changes the map
heading between north to the top of the
screen and vehicle heading to the top of
the screen.
F4 (Q-POI)
– Displays the list of Q-POI
classes, see
Quick points of
interest (Q-POI)
on page 3-4.
Enter
– Selects the map location under
the cross-wire marker as a destination or
memory point, see
Destination/point
selection.
Destination/point selection
The screen shows ‘Set as?
F1: Destination F2: Memory Point’.
Select the item required:
F1 (Dest.)
– A route to the selected map
location is calculated, see
Route
calculation
on page 6-1.
F2 (Mem.)
– The screen briefly shows
‘Point stored’.
JOL.312
JOL.313