Filter
Top Products
1 STARTER KIT
16 Copernicus GPS Receiver
7. Connect the USB cable to the USB connector on the interface unit.
Figure 1.7 Connecting the PC
8. Power-on your computer.
9. Insert the CD found in the starter kit box into your computer CD drive.
10. Install the Trimble GPS Monitor Program from the supplied CD. (see Trimble
GPS Monitor Toolkit, page 17).
11. Download and install the appropriate FTDI driver on your PC (see Install the
FTDI USB/Serial Driver Software, page 17).
12. Execute the Trimble GPS Monitor Program.
13. Select one of the USB virtual COM ports. Either the TSIP or NMEA data
stream is visible on your monitor. To view the other protocol, select a different
USB virtual COM port.