Filter
Top Products
Chapter 5 Command Reference
Serial Interface Communication
5-100 Operating and Programming Guide
Serial Interface Communication
The 59551A and 58503B GPS Receivers provide a set of commands that allow
you to configure the serial interface port(s) for instrument communications. A
set of special commands is provided for the 59551A Receiver since it has two
different serial ports (PORT 1, PORT 2).
Both Receivers have the rear-panel RS-232C serial interface port (PORT 1).
The 59551A has an additional front-panel RS-232C serial interface port
(PORT 2).
The following commands are provided to allow you to configure the ports.
!
Configuring I/O Port 1 <port> = SERial1 or SERial
Configuring I/O Port 2 <port> = SERial2 (59551A Only)
:SYSTem:COMMunicate?
:SYSTem:COMMunicate:<port>:BAUD ...
:SYSTem:COMMunicate:<port>:BAUD?
:SYSTem:COMMunicate:SERial1:BITS ... (59551A)
:SYSTem:COMMunicate:<port>:BITS?
:SYSTem:COMMunicate:<port>:FDUPlex ...
:SYSTem:COMMunicate:<port>:FDUPlex?
:SYSTem:COMMunicate:<port>:PACE ...
:SYSTem:COMMunicate:<port>:PACE?
:SYSTem:COMMunicate:<port>:PARity ...
:SYSTem:COMMunicate:<port>:PARity?
:SYSTem:COMMunicate:SERial1:SBITs ... (59551A)
:SYSTem:COMMunicate:<port>:SBITs?
!
Recovering the Last Query Response
:DIAGnostic:QUERy:RESPonse?