Filter
Top Products
connectivity, press the call key, or select Send ( ).
This option is not available during a call. You may not
be able to send video clips saved in the MPEG-4 file
format in a multimedia message.
You can also send the video clip to a person you are
talking to. Select Send to caller (
) (only available
during a call).
• To add the video clip to an album, select Add to album
• To upload the video clip to a compatible online album,
select
(only available if you have set up an account
for a compatible online album).
• To return to the viewfinder to record a new video clip,
press the capture key.
Camera settings
There are two kinds of settings for the camera: setup
settings and main settings. The setup settings return to
the default settings after you close the camera, but the
main settings remain the same until you change them
again. To adjust the setup settings, use the options in the
active toolbar.
See "Colour and lighting settings", p. 35.
To change the main settings, in the image or video mode,
select Options > Settings.
Still image camera settings
To change the main settings, in the image mode, select
Options > Settings and from the following:
Image quality — Set the resolution (main camera only).
The better the image quality, the more memory the image
consumes.
Add to album — Save the image to an album in Photos.
Record location — To add GPS location coordinates to
each image file, select On. Receiving a GPS signal may take
time or the signal may not be available.
Show captured image — Select whether to view the
captured image after it is taken or to continue image
capturing immediately.
Default image name — Define the default name for the
captured images.
Extended digital zoom — The setting is only available
in the main camera.On (continuous) allows the zoom
increments to be smooth and continuous between digital
and extended digital zoom, On (paused) allows the zoom
increments to pause at the digital and extended digital
step point, and Off allows a limited amount of zoom while
retaining the image resolution. Use the extended zoom
only when getting closer to the subject is more important
than the final image quality. The overall quality of a
digitally zoomed image is always lower than that of an
unzoomed image.
Capture tone — Set the tone that sounds when you
capture an image.
Memory in use — Select where to store your images.
Restore camera settings — Restore the camera settings
to default values.
Colour and lighting settings
In the active toolbar, select from the following:
Flash mode (
) (image only) — Select the desired flash
mode.
Colour tone (
) — Select a colour effect.
Switch video light on or Switch video light off
— Switch the video light on or off (video mode only).
35
Camera