Filter
Top Products
TRANSFER BOX
OVERHAUL 47
4. Raise intermediate gears until dummy shaft
LRT-41-004 can be inserted from front output
housing side of main casing.
5. Fit intermediate shaft, drift shaft into position
whilst at the same time expelling dummy shaft
LRT-41-004 .
CAUTION: Ensure ’O’ ring is not displaced
from main casing.
6. Remove wire from around intermediate gears.
7. Rotate intermediate shaft until retaining plate
can be located on flat on shaft.
8. Apply Loctite 290 to threads of retaining plate
bolt.
9. Fit bolt and tighten to 25 Nm (18 lbf.ft).
10. Fit a new intermediate shaft nut.
11. Tighten intermediate shaft nut in small stages
until all end-float is removed from intermediate
gears.
CAUTION: Check end-float of intermediate
gears between each stage, do not
continue tightening nut after end-float is
removed. Do not stake nut at this stage.
12. Set intermediate gear bearing pre-load
- See
Intermediate gear bearing pre-load.