Filter
Top Products
TRANSFER BOX
10
OVERHAUL
22. Invert front output housing.
23. Using a soft metal drift, drive differential
bearing track out of housing, discard bearing
track.
24. Remove selective shim.
Rear output housing
1. Position propeller shaft flange holding tool
LRT-51-003 to output shaft flange.
2. Remove and discard self-locking nut.
3. Remove steel and felt washers, discard felt
washer.
4. Remove output shaft flange together with
circlip.
NOTE: A replacement output flange will be
supplied together with new output shaft
oil seal.