TRANSFER BOX
4
OVERHAUL
27. Remove mainshaft input gear together with
taper roller bearings.
NOTE: Input gear fitted to Defender
transfer boxes has an additional dog tooth
gear - see inset on illustration.
28. Remove and discard mainshaft oil seal from
main casing.
CAUTION: Do not remove mainshaft input
gear bearing track at this stage.
29. Remove 6 bolts securing high/low cross shaft
housing.
30. Remove cross shaft housing.
31.
Up to serial no. 288709E:
Remove and
discard gasket.
CAUTION: Do not carry out further
dismantling of cross shaft housing at this
stage.