TRANSFER BOX
24
OVERHAUL
High/low selector fork and shaft
NOTE: There is no need to remove
selector fork from shaft unless fork or
shaft is to be replaced. If fork is removed,
coat threads of setscrew with Loctite 290 prior to
assembly.
1. Check detent grooves in shaft for wear.
2. Check high/low selector finger groove width in
shaft:
Groove width = 16.0 to 16.1 mm (0.63 to 0.64
in)
3. Check high/low selector fork for cracks and
wear.
4. Check high/low selector fork finger width:
Finger width = 7.37 to 7.47 mm (0.290 to 0.294
in)